Port St Lucie's Best Painting & Popcorn Ceiling Removal Services

End joints must be placed to prevent them from lingering from one row to the next. End joints should be offset by 16 inches or more.

Install the Final row

To make the final row, trim the grooved edge and install the planks. Install screws into the tracks to secure the planks against the wall. It would be best to leave a minimum expansion gap between the last row and the wall.

Add Moldings

Crown molding or another trim mold can be used as a cover for expansion gaps. They are attached to walls with brad nails. Use matching wood glue to fill in the nail holes.

How to cover popcorn ceilings with Tongue and Groove Planks and Bead Board Panels

A traditional way to cover a ceiling is with tongue-and-groove planks or beadboard paneling. It looks almost identical to the grid track system. This method is more labor-intensive but less expensive.

Mark Ceiling Joists

Locate the ceiling joists using a stud locater. Draw reference lines along the walls to indicate where the beams are located.

Install Insulation Panels If Desired

Insulate the ceiling with foam insulation panels placed against the ceiling surface if you choose.

Snap Chalk Lines

To mark the ceiling joist centers, place chalk lines across insulation panels after installing them. To show furring strips’ locations, keep these lines at intervals of 18 inches.

Name *

First

Last

Best Email: *

Best Phone Number: *

What City Are You Located In? *

How Soon Do You Need Our Services? *

How Can We Serve You? *

To Protect Against Spam, Solve The Math Problem Below: *

=

Yes, I’d Like a Free Quote!

Make a series of 1×2 furring strips and attach them to ceiling joists using drywall screws. You should use screws that penetrate the insulation panels to anchor them in the ceiling joists.

Check the furring strips in each direction with a carpenter’s ruler. Individual furring strips can be adjusted using shims placed underneath the anchoring screws if necessary.

Be patient when checking and correcting furring strips. To achieve good results using the panels or planks, you must ensure they are flat and level.

Install Tongue-and-Groove Planks and Beadboard Panels

To attach to furring strips, use a brad nailer and cut tongue-and-groove planks or beadboard boards to the correct size. Be sure to align the end joints from row to row. Allow for expansion by leaving a small gap between the walls and the floor.

Add Trim Molding

Cover the gaps between panels and planks with crown molding or another trim molding. The molding can be attached to the walls using a brad nailer.

Back in the ’60s, popcorn ceilings were huge. Popcorn ceilings were a fast and straightforward way to conceal imperfections. It can be hard to know how the popcorn ceiling will be removed because of the rough texture. It can be challenging to match popcorn ceilings with holes or cracks that require patching. Although removing a popcorn ceiling texture can be messy, it is well worth the effort if there is a suitable substrate underneath. Here are some ways to make popcorn ceiling removal easier.

Name *

First

Last

Best Email: *

Best Phone Number: *

What City Are You Located In? *

How Soon Do You Need Our Services? *

How Can We Serve You? *

To Protect Against Spam, Solve The Math Problem Below: *

=

Yes, I’d Like a Free Quote!